By default, backups are enabled in Kubernetes. Network storage latency and size should be taken into consideration for backups. 50MB for any single backup is a good estimate for storage requirements. For example, backups created every 15 minutes and retained for 1 day would store a maximum of 96 backups, requiring ~5 GB storage. If there is no intention to ever restore to a previous point in time, fewer historical backups may be retained.
When configuring Kubernetes, you can select whether or not backups should be enabled.
If backups are enabled, you can indicate the duration for the Backup Creation Period and Backup Retention Period.
The backup period durations must be a sequence of decimal numbers, each with optional fraction and a unit suffix, such as
2h45m. Valid time units are
The Backup Creation Period duration indicates at what rate backups should be created. It is not recommended to create backups more often than
The Backup Retention Period duration indicates at what rate historical backups should be deleted. Backups outside of the retention period are expired after the next successful backup.
The maximum number of backups stored on disk at any given moment follows the equation
ceiling(retention period / creation period). For example,
5m creation period with
4h retention period would store at most
ceiling(4h / 5m) backups or
48 backups. A conservative estimate for backup size is
50MB, so the attached network storage should have at least
2.4GB free space. Backup sizes will vary depending on usage.
If backups are disabled, the values for Backup Creation Period and Backup Retention Period are ignored.
Currently, backups are persisted to a static location on the host at
/var/etcd/backups. It is required that you mount a network storage at this location on all the hosts running the etcd service. Setting up the network storage must be done before Kubernetes is launched.
If all hosts running the etcd service fail, follow these steps:
disconnectedhosts and add new hosts. If you have opted to have resiliency planes, you will need to add hosts with the label
For each host that will be running the etcd service, mount the network storage containing backups, this should have been created as part of configuring remote backups. Then run these commands:
# configure this to point to the desired backup in /var/etcd/backups
# don’t touch anything below this line
docker volume rm etcd
docker volume create --name etcd
docker run -d -v etcd:/data --name etcd-restore busybox
docker cp /var/etcd/backups/$target etcd-restore:/data/data.current
docker rm etcd-restore
> Note: You must be logged in as a user with read access to the remote backups. Otherwise, the
docker cp command will silently fail.